What is the line pattern on the surface of the wire drawing machine?

Source:

YOUMALE

The workpiece is conveyed by the conveyor belt through the non-woven roller brush, and the roller brush rotates at a high speed to draw the surface of the workpiece. The thread pattern on the surface of this drawing is usually a straight thread with continuous thread pattern. The abrasive belt grinds and draws the surface as a whole, which will generate a lot of heat and cause stress concentration on the drawing side of the workpiece, especially for thin-walled parts, which will cause warping and deformation.

When the wire drawing machine is drawing, there are two ways of roller brush vibration and roller brush non-vibration, and at the same time, with different processing speeds, lines of different lengths can be generated. The abrasive belt rotates at a high speed, and the plate is polished and drawn by the conveyor belt through the abrasive belt. Usually stainless steel plates, aluminum alloys and other plates are made into semi-finished products of drawing, so as to be further made into products with plates as raw materials, such as stainless steel elevator wire drawing door panels, stainless steel plates, etc. Counter, aluminum alloy case, etc.

The key to the operation of the flat wire drawing machine is to try to obtain a high polishing rate so as to remove the damage layer produced during polishing as soon as possible. The former requires the use of coarser abrasives to remove the polished damage layer with a larger polishing rate, but the polishing damage layer is also deeper; the latter requires the use of fine materials to make the polishing damage layer shallower, but the polishing rate is low. .

After the surface of the aluminum plate wire drawing machine is sprayed, there may be small defects on the surface of the paint film such as coarse grains, sandpaper marks, flow marks, anti-white, orange peel, etc. It consists of basic components such as cover and cover. The motor is fixed on the base, and the taper sleeve for fixing the polishing disc is connected with the motor shaft through screws.

Key words:

Straight Wire Drawing Machine / Water Tank Wire Drawing Machine / Inverted Wire Drawing Machine / Annealing Furnace / Take-up and Pay-off Unit / Rewinding Machine

Back to List

More information

The solution to the power consumption problem of the inverted wire drawing machine

05-11

What are the wire drawing lubrication methods of the wire drawing machine?

05-11

What is the classification and main structure of the wire drawing machine?

05-11

Application advantages of copper alloy wire drawing machine controller

05-11

Measures to avoid new scratches in the grinding of plane wire drawing machine

05-11